Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On

$49.99 Buy It Now or Best Offer
free,30-Day Returns

Seller Store caraudioninja
(0) 0.0%,

Location: Rocklin, California
Ships to: US,
Item: 405334842023

All returns accepted:ReturnsNotAccepted
wāvtech:wāvtech
Wavtech linkD:Wavtech linkD

About the Wāvtech linkD Provides a strong clean signalYour aftermarket processors and amplifiers need strong and clean input signals, whether getting them from a receiver’s RCA outputs or a factory amp’s speaker outputs. Wāvtech’s linkD can produce up to 10 volts of output in either scenario, acting as a line driver using its RCA inputs or as a line output converter using the speaker-level inputs.Works with factory ampsThose speaker-level inputs can handle up to 40 volts, the equivalent of 400 watts, so you can use one in a premium system with a factory amplifier. This way you retain all your vehicle’s factory audio options and warnings. The linkD’s gain control and clip light help you keep the signal level under control and distortion-free.Product highlights:active 2-channel line driver/output converterdesigned to work with aftermarket and factory systemsprovides up to 10Vrms outputpreamp and speaker-level inputsselectable speaker-level input sensitivity (20V or 40V) via internal jumperauto turn-on via DC offset or audio detectgain control and clip lightMore Info:12-volt turn-on lead outputspeaker-level inputs feature load resistance to prevent factory stereo shut-downoptional plug-in parallel load resistors available for vehicles like some newer Chrysler vehicles that need less resistance for the factory stereo’s load-sensing to workwiring, fuse, and hardware not included with device18-gauge power and ground leads and a 1-amp fuse recommendeddimensions (not including terminals and jacks): 2-13/16″W x 1-1/8″H x 2-15/16″Dwarranty: 1 year60-day returnsMFR # LINKDItem # 241LINKDWhat’s in the box:Wāvtech linkD owner’s manual2-Channel line output converter/line driver2 Phoenix terminals (installed)2 Mounting tabs (installed)Two ½ » ScrewsGround ring terminalOwner’s manualFeaturesOverview: The linkD is an active 2-channel line output converter and line driver, with speaker level and RCA inputs.Speaker Input: The speaker level inputs are compatible with most factory stereo systems. They will accommodate up 40 volts RMS per channel (equivalent to 400 watts at 4Ω). The balanced-differential input design minimizes the possibility of having noise induced into the signal.Load Detect Compatible: The speaker level inputs are loaded to simulate the factory system seeing a speaker. If a lower impedance is needed, the linkLD external parallel load can be added to the speaker inputs.Output Level: The 10 volt RMS maximum allows you to adjust output voltage to the top of your amp’s input range.Clip Indicator: An onboard LED indicates when the output signal is too high and is clipping, making it easy to maximize the output levels without distortion.Auto Turn-on: The speaker level inputs have a DC-offset circuit, and both the speaker level and RCA inputs have a signal sensing circuit. The unit turns on when there’s an input signal and turns off when the signal disappears. There is also a +12 volt remote turn-on input and the auto turn-on circuits can be disabled.Ground Isolation: The internal audio signal ground is switchable, in case of ground loop noise. The factory position is chassis ground (typically the best choice), but can be changed to 200Ω or ISO (isolated).Terminal Blocks: The power/ground/remote-in/remote-out terminal and the speaker level inputs are removable Phoenix terminals (Euroblock). The wiring is attached to the block, then the block is plugged into the chassis. The terminal blocks will accommodate wire up to 16-gauge.Connections:Power: removable 4-pin Phoenix terminalGround: minimum 18-gauge wire recommended+12 volts: minimum 18-gauge wire recommended with a 1-amp fuse (not included)Remote In: unit turns on when +12 volts applied to this terminalRemote Out: +12 volt output when unit is on (used to turn on amp, 500 mA max)Speaker Level Inputs: removable 4-pin Phoenix terminalLine Inputs: stereo RCA jacksLine Outputs: stereo RCA jacksControls:Gain: rotary dialGround Reference: three jumper positions; ground (factory setting), ISO, or 200ΩHidden Controls: There are several jumper pins inside the linkD chassis, to make adjustments that are not typically necessary:Speaker Level Input Sensitivity Range: The 2-position jumpers are set to 2-20 volts RMS (factory setting) or 4-40 volts RMS. (There are separate jumpers for the left and right channels.)RCA Input: The 2-position jumpers are set to Balanced (factory setting) or Unbalanced. (There are separate jumpers for the left and right channels.)Auto Turn-on: The DC-offset and audio signal sensing circuits can be independently turned off. The factory setting for both is on. When either jumper is removed, that circuit is disabled.Specifications:Frequency response:+0/-1 dB: 18 Hz-75 kHz+0/-3 dB: 15 Hz-100 kHzInput Impedance:Speaker input: 180 ΩRCA input: 20 kΩInput Sensitivity:Speaker input: 2-40 volts RMSRCA input: 0.5-5 volts RMSOutput Impedance: 50 ΩMaximum Output Voltage: 10 volts RMSTHD+N:Using Speaker input: 0.1% (at 10 volts output)Using RCA input: 0.01% (at 10 volts output)S/N:Speaker input:1 volt output: 95 dBA4 volt output: 105 dBA10 volt output: 112 dBARCA input:1 volt output: 98 dBA4 volt output: 110 dBA10 volt output: 115 dBACurrent Draw:Operating: 200mA (without remote out)Standby: 1mADimensions:Width: 3¾ » (4¼ » including cables)Height: 1¼ »Depth: 3″

Frequently Asked Questions About Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On in My Website

humusjardin.com is the best online shopping platform where you can buy Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On from renowned brand(s). humusjardin.com delivers the most unique and largest selection of products from across the world especially from the US, UK and India at best prices and the fastest delivery time.

What are the best-selling Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On on humusjardin.com?

Humus Jardin

Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On

Frequently Asked Questions About Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On in My Website

What are the best-selling Wavtech linkD 2-Channel LOC / Line Driver 10Vrms Auto Turn-On on humusjardin.com?

Laisser un commentaire Annuler la réponse